Phrozen Nylon-Green Tough Resin - 1 Kg

Phrozen Nylon-Green Tough Resin - 1 Kg

1. Viscosity: 742 cps
2. Proportion: 1.1
3. Tg: 73 °C
4. Elongation: 130%
5. Break Value: 19 MPa
6. Hardness: Shore 68 D
7. I-Zod Impact: 23.79 KJ/m2
8. Weight: 1KG per bottle
9. XY Resolution: 0.047 mm
10. Layer Height / Parameter: 10 sec @ 50 um, Delay 3
11. Ways to Rinse: Use alcohol spray to clean models and dry it by an air gun. Do not immerse printed part into alcohol over 30 sec.
12. Compatible Printer: Phrozen 3D Printer Series
13. Application: Prototyping

• Avoid sun light exposure.
• After printing, stored used resin in closed and opaque bottle. ​​
• DO NOT mix fresh resin with used resin.
• Shake or stir resin properly to avoid pigment separation.
• DO NOT dump resin. Please cured resin and treat/recycle it as general plastics garbage.
• Do your best to wear glove, goggles, long sleeves shirt during usage of resin. Wash hands after using resin.
• DO NOT swallow resin. Go to hospital if you do.
• Avoid eye contact by resin. Rinse with water and go to hospital if resin contacts eyes.
• Resin might cause slight skin irritation. Stop using it if allergy occurred.
• Resin smells. We strongly suggest you use it under ventilated conditions.
• Keep resin in room temperature(15 - 35 Celsius) and dry condition.
• Keep resin away from kids.